JDM ITR Header? Better than the rest?
07-14-2002 | 02:11 PM
#1
Thread Starter
Member
Joined: Jun 2002
Posts: 30
Likes: 0
From: Miami
JDM ITR Header? Better than the rest?
Im going to the dyno in like 2 weeks, and right now i have a comptech header on my car...i want to try a a couple setups for my ITR so i was wondering if the JDM ITR header is better than the comptech, or the dc sports JDM... and if so...anyone know where i can get one? The JDM ITR one...thanks in advance...latz
07-14-2002 | 06:25 PM
#2
been there done that
Joined: Jun 2002
Posts: 30,637
Likes: 0
From: 916
dont know which one is better but here are a few sites that sell it along with the heat shields:
www.jdmhondaparts.com
www.inlinefour.com
www.optionsauto.com
www.jdmhondaparts.com
www.inlinefour.com
www.optionsauto.com
07-14-2002 | 06:38 PM
#3
Moderator
Joined: Jun 2001
Posts: 11,776
Likes: 0
07-15-2002 | 07:31 PM
#7
Registered User
Joined: Nov 2000
Posts: 2,715
Likes: 1
From: Virginia (Besieged)
The JDM OEM header is not the absolute best.
However, it's probably the best quality bang for the buck.
A JDM OEM header and Carsound cat is probably good for 8 wheel horses over stock, and the new power's through the rev range.
It's a really good buy if your funds are limited, and because it's OEM, you can make it look stock by using the OEM JDM heat shields. No hassles during state inspections.
However, it's probably the best quality bang for the buck.
A JDM OEM header and Carsound cat is probably good for 8 wheel horses over stock, and the new power's through the rev range.
It's a really good buy if your funds are limited, and because it's OEM, you can make it look stock by using the OEM JDM heat shields. No hassles during state inspections.
08-01-2002 | 11:14 PM
#9
Member
Joined: Jul 2002
Posts: 42
Likes: 0
From: Miami
Yeap i sure did...both had the same thing..i have the comtech header and aem cai..he has the jdm header and aem cai...howd you hear? We went form a 1st gear roll at v-tec...i counted to 3 and then punched it..i got the jump on him though..
..old tricks of racing..i was only a bumper ahead...
..old tricks of racing..i was only a bumper ahead...
08-02-2002 | 07:42 AM
#10
Junior Member
Joined: Aug 2002
Posts: 19
Likes: 0
From: The bubble of Irvine- it cant be burst
well i believe the comptech one is a 4-2-1 design where as both jdm headers are 4-1 so the difference between the two would be one that produces more low-mid and the two others that produce mid-high. So its all a matter of preference when it comes to choosing. do you want low end or high end?