Ok guys i have been having wired problems with integra a bit of background my car recently got new Axle boots, (From dealership) but they did it wrong, so ended having to do whole axle. Well thought problem was fixed, BUT today when accelerating on the freeway about 45-65 it started shaking violently. Now idea what the hell was going on. Now i am worried, any suggestions? Thanks, Brian

 

one of the axels are still messed up. Have them recheck the job they did.

Sorry wait! Does it shake while your accelerating or just when you hit past 45mph?

 

after 40-50 miles per hour about..

 

They most have left something lose somewhere. Just bring it back to them

 

Shoulda had me do it.

 

LOL ya, wish i would of known. Hope your engine is doing better.

 

tested it again and i notice a clunk clunk clunk the most when slowing down. Shaking is gone for right now... Wtf is going on.....

 

Take it back to the shop that made the last repair and explain to them them the problem. Most shops will be happy to recheck there work.

 

I wouldnt rule out the axle being out of balance. In extreme cases, what you're experiencing happens.

Most factory axles have rubber damper rings to offset the resonance. Aftermarket rebuilds tend not to have the dampers causing funky weirdness at times.

then again, it could be an install issue

 

took it again today they said their is nothing wrong with it??!! Oh well maybe if axle breaks on freeway i can get a check and get a GSR Integra.