GSR exhaust VS. ITR exhaust
#1
GO GIANTS!
Thread Starter
Join Date: Jul 2002
Location: Alameda, CA
Posts: 264
Likes: 0
Received 0 Likes
on
0 Posts
GSR exhaust VS. ITR exhaust
Had a quick question.....I'm a lil tired of the aftermarket exhausts nowadays...getting a lil old ....so I was wondering if an ITR cat back exhaust would bolt up to my 95 GSR with no problems. Is the piping the same, and will it fit onto my cat? Or do you think it's a waste of money? Any ideas or opinions would be appreciated...thanks
#7
Junior Member
Join Date: Jun 2002
Location: Dublin, OH
Posts: 23
Likes: 0
Received 0 Likes
on
0 Posts
The Type-R Cat-back exhaust is 57.2mm (2.25") mandrel bent piping [an increase of +6.4mm~8.6mm over stock] throughout to increase air flow. The muffler is a multi-chamber design, and does a wonderful job of dissipating sound. However, the funnel-shaped piping in-between the chambers makes it a very free-flowing exhaust. Furthermore, in order to lighten/strengthen the parts, stainless steel was used.
The B-pipe will need to be extended 4.5" if it is installed on a '94-'99 GS-R because it has a shorter cat than the other Integras.
The B-pipe will need to be extended 4.5" if it is installed on a '94-'99 GS-R because it has a shorter cat than the other Integras.
#9
GO GIANTS!
Thread Starter
Join Date: Jul 2002
Location: Alameda, CA
Posts: 264
Likes: 0
Received 0 Likes
on
0 Posts
Originally posted by BSQ
The Type-R Cat-back exhaust is 57.2mm (2.25") mandrel bent piping [an increase of +6.4mm~8.6mm over stock] throughout to increase air flow. The muffler is a multi-chamber design, and does a wonderful job of dissipating sound. However, the funnel-shaped piping in-between the chambers makes it a very free-flowing exhaust. Furthermore, in order to lighten/strengthen the parts, stainless steel was used.
The B-pipe will need to be extended 4.5" if it is installed on a '94-'99 GS-R because it has a shorter cat than the other Integras.
The Type-R Cat-back exhaust is 57.2mm (2.25") mandrel bent piping [an increase of +6.4mm~8.6mm over stock] throughout to increase air flow. The muffler is a multi-chamber design, and does a wonderful job of dissipating sound. However, the funnel-shaped piping in-between the chambers makes it a very free-flowing exhaust. Furthermore, in order to lighten/strengthen the parts, stainless steel was used.
The B-pipe will need to be extended 4.5" if it is installed on a '94-'99 GS-R because it has a shorter cat than the other Integras.
So if I extend the piping, will it line up to the cat? I have a feeling I would need a new cat. And if I do, then do I need an ITR header?
Basically, can I just bolt up the ITR exhaust to the cat. or do I need the ENTIRE system, header, cat and exhaust?