well i found this spot sneaking up on me while i was rinsing off the teggy today. how does this rear fender liner come off so i can fix this before it becomes more than surface rust. i tried peeling back that little bit that comes all the way up to the edge, but it seems like its glued on.

 

u mean the rubber strip around the wheel well? Mine just pulled off. The rubber is VERY stif and did fell like it was glued on but just keep pulling. I kept mine off, These actually CAUSE RUST. water will sit there and stay. ESPICALLY near the rear bumer area

 

are those connected to the fender liner at all or are they a seperate piece? i may just remove them if they will cause rust

 

seperate piece

 

Honda Rot!

 

ok, that stuffs comin off tomorrow...i felt behind it and its not rusted through so hopefully its all surface....ugh, my first rust spot.

 

yup

 

thats good news

 

yeah that sucks...haven't found any on my shitbox just yet... hoping to not come across any after the winter is over (hnoes: winter in so cal... 1" of rain and 70* weather how will we survive) ... but i think if i remember correctly there are a couple push pins that love to crack and break on u holding the wheel well against the fender...once those are off, it's much easier to remove the rubber

 

it should just pull off, took mine off last weekend, i'm hoping that i dont kick any sticks up and screw up the fender