upgraded my IM with a skunk2 IM and only thing i didnt do was the ITR cable. anyone done this yet? im sure its been done here a lot but 1. how hard is it, 2. found them new on ebay for 25 bux, is it worth it or should i go look in the yards. thanks. picks would help too.

 

bump, cause i think eventually i'd like to put the ls/itr throttle cable on my setup too

 

I have the LS pulley and ITR throttle cable ready when my Skunk2 manifold goes in in two weeks. I'll keep you guys updated when it goes in if there is no one else to let you know.

 

on my skunk2 intake i just reused my gsr throttle cable, the only thing i bought was the ls/type R throttle cable bracket and it worked perfect!

 

I don't know about perfect.

It isn't perfect, but it will work.

 

well seeing how i have had it like that for a long time, and it dosen't effect anything as far as performance or functionality i would say it works perfect, it may not look as pretty but i don't think that should constitute it not working perfectly fine

 

Yes, but you have to admit that your throttle doesn't feel the same as my car. I am sure that if you got the right throttle cable and throttle pulley, it would feel the same.

 

well see in two weeks when we do your car ahahahha, if it turns out good i will change that pulley, if there is some fuctionality and performance difference

 

Yeah, it looks promising.

Are you not going to change the throttle cable?

 

no i will change that as well!