Honda-Acura.net

Notices
Engine Swaps, Tech & Tuning Swaps, N/A Performance, Forced Induction, Engine Management, & Troubleshooting

exhaust manifold bolt torque!!! HELP

Thread Tools
 
Old 05-25-2003, 04:19 PM
  #1  
ZiviCase10287
RacinMasonC
Thread Starter
 
ZiviCase10287's Avatar
 
Join Date: Jan 2003
Location: Minnesota
Posts: 1,166
Likes: 0
Received 0 Likes on 0 Posts
Default exhaust manifold bolt torque!!! HELP
on a D16a6 whats the torque specs on the header bolts?? the bolts that bolt the header on the cylinder head??? it should be the same all through the years but if its not its an 88 crx si engine, thanks for any help at all!!!

btw - its gotta be in ft/lbs!! thanks!
ZiviCase10287 is offline  
Reply Like
Old 05-26-2003, 04:07 AM
  #2  
ZiviCase10287
RacinMasonC
Thread Starter
 
ZiviCase10287's Avatar
 
Join Date: Jan 2003
Location: Minnesota
Posts: 1,166
Likes: 0
Received 0 Likes on 0 Posts
Default
anyone?
ZiviCase10287 is offline  
Reply Like
Old 05-26-2003, 06:27 AM
  #3  
rev
Senior Member
 
rev's Avatar
 
Join Date: Nov 2002
Location: Nashville
Posts: 115
Likes: 0
Received 0 Likes on 0 Posts
Default
Never have used a torque wrench on those, but figure a 8mm bolt torques to roughly 25-28ft lbs. I would only torque them to about 25 though.
rev is offline  
Reply Like
Old 05-26-2003, 10:28 AM
  #4  
ZiviCase10287
RacinMasonC
Thread Starter
 
ZiviCase10287's Avatar
 
Join Date: Jan 2003
Location: Minnesota
Posts: 1,166
Likes: 0
Received 0 Likes on 0 Posts
Default
ok thanks
ZiviCase10287 is offline  
Reply Like
Back to Subforum
Engine Swaps, Tech & Tuning
View Next Unread
tapping into vacuum cleanly




Advanced Search
Reply Closed Thread Share
Forum Jump

All times are GMT -8. The time now is 10:05 AM.