what head?????
#1
Member
Thread Starter
Join Date: Jul 2003
Location: NC
Posts: 47
Likes: 0
Received 0 Likes
on
0 Posts
what head?????
yo, im wondering since i cant do my engine swap and ive learned that i could put a new head on and gain some hp, im wondering what head is compatable with a D15B2 and will gain the most HP for my money i can install it myself so labor cost is not needed, i want some major HP out of it.............also what cam should i use? the one out of the head or a new one? and i also wanna know if i can put a DOHC head on my SOHC D15B2 wether its vtec or not
#5
I'm RICK JAMES, bitch!
Join Date: Mar 2002
Location: Baltimore, Md
Posts: 4,742
Likes: 0
Received 0 Likes
on
0 Posts
No you can't put a DOHC head on your SOHC block, you could put a jet engine in your car, but that doesn't mean you should do it.
Like I told you before. I think the Z6 head would be the best, and convert the car to OBD-I.
Like I told you before. I think the Z6 head would be the best, and convert the car to OBD-I.
#7
I'm RICK JAMES, bitch!
Join Date: Mar 2002
Location: Baltimore, Md
Posts: 4,742
Likes: 0
Received 0 Likes
on
0 Posts
I know it can be done on 4G63 Mitsubishi engines also. But we aren't on Mitsubishi-Toyota.net. Were talking Hondas here, and on Honda engines you can't do that.
#8
Rotorphile.
Join Date: Mar 2002
Location: Richmond, VA
Posts: 10,120
Likes: 0
Received 0 Likes
on
0 Posts
An interesting little tidbit: apparently the browntop ZC and the EW/D15A3 blocks mate with little to no problems, aside the fact that no-one has figured out what timing belt to use yet There was some discussion about it over at redpepperracing.com, but it hasn't been updated for a while. I've been seriously considering buying a ZC head and a D15A3 block and seeing for myself.
Granted, these are both pre-88 engines.
Granted, these are both pre-88 engines.