throwing ecu code 9
#1
Registered User
Thread Starter
Join Date: Mar 2003
Location: Tucson AZ
Posts: 1,412
Likes: 0
Received 0 Likes
on
0 Posts
throwing ecu code 9
what would cause this code
Code 9 _____ No. 1 cylinder position (only on 1.6L)
on hf ecu with zc engine? or will it not allow me to use this ecu at all? new one coming in a few days but i want to fire it up now
Code 9 _____ No. 1 cylinder position (only on 1.6L)
on hf ecu with zc engine? or will it not allow me to use this ecu at all? new one coming in a few days but i want to fire it up now
#2
Registered User
Thread Starter
Join Date: Mar 2003
Location: Tucson AZ
Posts: 1,412
Likes: 0
Received 0 Likes
on
0 Posts
ok fixed that problem blue wire connector wasnt pushed in all the way now what are the correct way for the distributor wires to the plugs? how are they attached? motor isnt starting
#4
I'm RICK JAMES, bitch!
Join Date: Mar 2002
Location: Baltimore, Md
Posts: 4,742
Likes: 0
Received 0 Likes
on
0 Posts
Ok on the fire wall you will see a black thing with vacuum hoses coming off of it. The hose for the Map sensor (a black box with the hose coming out facing downward, it will say MAP SENSOR on it if you look hard enough) that hose goes to the little tube sticking out of the top of your Throttle Body. On my car there was only one other hose and that was a hose coming out of an emissions valve or something (a black cylinder looking thing near the MAP sensor) and I just left that unplugged. I'm going to look for a picture.