Finished ZC install today, also put in some Sedan Handles...
#1
I'm RICK JAMES, bitch!
Thread Starter
Join Date: Mar 2002
Location: Baltimore, Md
Posts: 4,742
Likes: 0
Received 0 Likes
on
0 Posts
Finished ZC install today, also put in some Sedan Handles...
Finshed my ZC swap today. However it won't start up. It has spark and fuel at least to the rail. I think it might be an injector issue (possibly they are not getting power to them).
I also had time to install the Sedan Handles I got from the junkyard, bye bye Key Holes...
Here is a How-To for the Sedan Handles...
http://www.fourthgenhatch.com/sedanhandles.html
I also had time to install the Sedan Handles I got from the junkyard, bye bye Key Holes...
Here is a How-To for the Sedan Handles...
http://www.fourthgenhatch.com/sedanhandles.html
#4
Registered User
Join Date: Mar 2003
Location: Tucson AZ
Posts: 1,412
Likes: 0
Received 0 Likes
on
0 Posts
whats going on with the engine? not turning over? not starting when turning over, if u give us some more info maybe we could figure out the problem for u, or give u some suggestions if u'd like
#5
Rotorphile.
Join Date: Mar 2002
Location: Richmond, VA
Posts: 10,120
Likes: 0
Received 0 Likes
on
0 Posts
Originally written by FourthGenHatch
Removing the sedan handles is easy because you can just rip out the door panels and all that stuff, hey it isn't your car, right?!
Removing the sedan handles is easy because you can just rip out the door panels and all that stuff, hey it isn't your car, right?!
Nice looking swap, too bad it doesn't run yet. Are you planning on leaving the intake like that?
#6
I'm RICK JAMES, bitch!
Thread Starter
Join Date: Mar 2002
Location: Baltimore, Md
Posts: 4,742
Likes: 0
Received 0 Likes
on
0 Posts
Originally posted by Kai
Junkyard etiquette
Nice looking swap, too bad it doesn't run yet. Are you planning on leaving the intake like that?
Junkyard etiquette
Nice looking swap, too bad it doesn't run yet. Are you planning on leaving the intake like that?
As for the car not running I have improved upon the situation but not solved it. It was throwing code 10 for TA sensor. I swap around 2 connectors and that solved it. Still doesn't start. I then bought new spark plugs. Fires stronger but still doesn't start. I now believe it is a problem with it getting fuel. I used a B18A fuel hose and that is not working so hot with the ZC. So tomorrow I'm going to the junkyard where I know there is a AWD wagon that should have the D16A6 parts.
#9
I'm RICK JAMES, bitch!
Thread Starter
Join Date: Mar 2002
Location: Baltimore, Md
Posts: 4,742
Likes: 0
Received 0 Likes
on
0 Posts
The starter works fine, the engine just doesn't start. I don't think my Distributor could be wired up wrong, there was no really wiring for it.
#10
is your fuel pump running when you turn it to "on" position?...it could also be the fuel filter stopping up gas flow
i hope you are not throwing code 21 or 18 [15...can't remember the number] (dist or ecu related)
i hope you are not throwing code 21 or 18 [15...can't remember the number] (dist or ecu related)