Hyper-Flex Suspension Bushings
#1
HC Racer H5
Thread Starter
Join Date: May 2000
Location: KCK
Posts: 4,261
Likes: 0
Received 0 Likes
on
0 Posts
Hyper-Flex Suspension Bushings
Just got my ES master kit for my rex...now i need new coilovers and shocks, front radius arm bearings and rear trailing arm bearings (replaces the bushings)
#2
GWAKS- Tech Geekifier
Join Date: Oct 2000
Location: Hampton, VA
Posts: 2,109
Likes: 0
Received 0 Likes
on
0 Posts
that's a whole lotta bushings...
__________________
-Harry
AIM: NDcissive
CRX and Pre '92 Civic, Engine Tech and Tuning, & Track and Autocross Forum Mod
-Harry
AIM: NDcissive
CRX and Pre '92 Civic, Engine Tech and Tuning, & Track and Autocross Forum Mod
#5
HC Racer H5
Thread Starter
Join Date: May 2000
Location: KCK
Posts: 4,261
Likes: 0
Received 0 Likes
on
0 Posts
i'm going to do this project in spring time...i have to still buy the shocks, coilover kit, springs and suspension bearings...i'll probably do a helper journal when i do it
the kit goes for $130 at www.inlinefour.com but i found someone selling a new in box kit through the classifieds and got it for even cheaper
the only pain in the ass is finding which bushing goes to what since none are labeled and the parts list doesn't give a pic of each part
the kit goes for $130 at www.inlinefour.com but i found someone selling a new in box kit through the classifieds and got it for even cheaper
the only pain in the ass is finding which bushing goes to what since none are labeled and the parts list doesn't give a pic of each part
#6
GWAKS- Tech Geekifier
Join Date: Oct 2000
Location: Hampton, VA
Posts: 2,109
Likes: 0
Received 0 Likes
on
0 Posts
Originally posted by jaje
the only pain in the ass is finding which bushing goes to what since none are labeled and the parts list doesn't give a pic of each part
the only pain in the ass is finding which bushing goes to what since none are labeled and the parts list doesn't give a pic of each part
#7
HC Racer H5
Thread Starter
Join Date: May 2000
Location: KCK
Posts: 4,261
Likes: 0
Received 0 Likes
on
0 Posts
Originally posted by 1stGenCRXer
Actually, the part numbers should be molded into the bushings in small print. Def. a PITA, but shouldn't be impossible.
Actually, the part numbers should be molded into the bushings in small print. Def. a PITA, but shouldn't be impossible.
#8
GWAKS- Tech Geekifier
Join Date: Oct 2000
Location: Hampton, VA
Posts: 2,109
Likes: 0
Received 0 Likes
on
0 Posts
Originally posted by jaje
thanks for the tip...i didn't want to cut them off hte sheet b/c i won't install them for a couple months...but i can see the numbers kinda...
thanks for the tip...i didn't want to cut them off hte sheet b/c i won't install them for a couple months...but i can see the numbers kinda...
#10
HC Racer H5
Thread Starter
Join Date: May 2000
Location: KCK
Posts: 4,261
Likes: 0
Received 0 Likes
on
0 Posts
Originally posted by 91_hatch_si
What are bushing used for?
What are bushing used for?