No Reverse after tranny rebuild
#1
No Reverse after tranny rebuild
I just recently bought a used transmission, replaced the infamous input shaft bearing and swapped it out with my old transmission. The trans I bought was in great shape, low miles, and runs great but I don't have reverse. Is there a common mistake that people make when re-assembling? Ya I know I will probably have to tear the thing down again!
#3
Got it in to reverse today, it really loosened up after the initial engagement....and driving it around the neighborhood for a couple of blocks, what a weird way to get laughed at! Anyways just for the thread, I spoke with some transmission specialists. If you don't use your parts cleaner when handling any of the internals, it is going to be a pain in the rear almost every time after assembling. Lesson learned, think clean!