RedlineBoyzCRX

Ok, So I would like to know what a good fuel pressure would be. This is my setup. What should my fuel pressure be set at?

Engine:
JDM B16a1 Swap
3" Intake
AZ Race Motor Mounts
B&M Fuel Pressure Regulator
Crane Cams Ignition Wires
GSR Water Pump
ITR Injectors
ITR Throttle Body
Koyo Racing Radiator
MSD Blaster SS Ignition Coil
MSD Pro Distributer Cap
NGK V-Power Spark Plugs
Skunk 2 Short Shifter
Tanabe Racing Medallion Exhaust

Head:
3 Angle Valve Job
ARP Head Studs
Billet Spark Plug Cover
CTR Cams
Hondata Intake Manifold Gasket
KMS Silicon Bronze Valve Guides
OmniPower Retainers
Port & Polish
Port Matched
Skunk 2 Dual Valve Springs
SuperTech Valves
Toga Performance Valve Seals
Type-R Valve Cover

Block:
King Performance Racing Main Bearings
King Performance Racing Rod Bearings
Type-R Crank Pulley
Type-R Pistons


Transmission:
S1 Tranny
F1 Racing Stage 2 Clutch
Fidanza Aluminum 7.5lb Flywheel

Suspension:
Drop Zone Camber Kit
Front Tie Bar
Rear Tie Bar
Rear Strut Bar
Skunk 2 Coilovers
Titan Tower Strut Bar
Tociko HP Shocks

Electronics:
Apexi VAFC 2
Custom Engine Wiring Harness
Mugen Chip ECU

ED9man

Can you like boil that down to useful information concerning the fuel pressure?

RedlineBoyzCRX

What would be a good fuel pressure to have on my car? What PSI?

daveb91

42psi

daveb91

Any other fuel mods should be done with your vafc

RedlineBoyzCRX

Alright, thanx, I found that ouit from Schmoo, he game me like 41-42 PSI. I wass jsut wonrding, casue I have no clue what my Fuel PRessure is at right now.

daveb91

Buy a gauge they are very cheap.

RedlineBoyzCRX

I got an Autometer.

daveb91

Why do you ask this if you have a gauge?

RedlineBoyzCRX

I asked becasue I have a FPR and I need to set what my Fuel pRessure Will be. And I need the gauge to read what I am settings it at.
Now who's question looks stupid?