What else would i need for a B16 swap
09-08-2002 | 05:10 AM
#1
Thread Starter
Member
Joined: Aug 2002
Posts: 77
Likes: 0
From: Smithsburg, MD
What else would i need for a B16 swap
The engine come with...
5 Spd. Transmission, Alternator, Starter Motor, AC Compressor, Distributor, and the Power Pump.
I would also be getting a Stage 2 Clutch, and Headers (ceramic or stainless steel....which ones?)
Would i need an ECU what about Axles?
I have an 88 Si.
5 Spd. Transmission, Alternator, Starter Motor, AC Compressor, Distributor, and the Power Pump.
I would also be getting a Stage 2 Clutch, and Headers (ceramic or stainless steel....which ones?)
Would i need an ECU what about Axles?
I have an 88 Si.
09-08-2002 | 05:24 AM
#2
Senior Member
Joined: Jun 2002
Posts: 967
Likes: 0
From: Denver, CO
Most commonly people say axles from a 90-93 Teg. you cna check out www.raxles.com Kind of pricey, but i"ve heard good things about them.
PR3 or a PWO ecu.....the PR3 is recommended.
I'd get stainless steel headers.
If you're getting an ew clutch you might as well get a lightened flywheel too. You won't regret that purchase!!!!
Don't forget mounts and harness.
PR3 or a PWO ecu.....the PR3 is recommended.
I'd get stainless steel headers.
If you're getting an ew clutch you might as well get a lightened flywheel too. You won't regret that purchase!!!!
Don't forget mounts and harness.
Thread
Thread Starter
Forum
Replies
Last Post
ACT I
Integra & 97-01 Integra Type-R
4
12-21-2005 09:42 AM
dirtydozen
92+ Civic/EL & Del Sol
2
08-29-2004 12:58 PM
Vividkid82
CRX & Pre 92 Civic
3
11-04-2003 06:52 PM