a few b16a questions
#1
a few b16a questions
i own a 90 hatch and i have a b16a from a jdm integra XSI. i was wondering if anyone has this setup with high performace axles. where did u get them? and also i was going to buy a 2000 integra type-r intake manifold will it fit between the block and the firewall?
#3
Rotorphile.
Join Date: Mar 2002
Location: Richmond, VA
Posts: 10,120
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by Dosvita
i was wondering if anyone has this setup with high performace axles.
#4
i deliver chinese food in my civic and i am hell on the knuckles, the oem integra ones ripped out in less than a month. just trying to figure it out so i can stop with the vibration. who said it was stock
#5
Rotorphile.
Join Date: Mar 2002
Location: Richmond, VA
Posts: 10,120
Likes: 0
Received 0 Likes
on
0 Posts
I didn't say it was stock, my statement required a little thought on your behalf. I'll make it a simpler for you: you should be in the 300ft-lb wheel torque range to before you need to be concerned about braking axles.
I don't know how delivering food would hurt the car in that respect.
I don't know how delivering food would hurt the car in that respect.
#7
Senior Member
Join Date: May 2003
Location: Long Island, NY
Posts: 1,052
Likes: 0
Received 0 Likes
on
0 Posts
are you using the correct intermediate shaft? u should use the integra shaft with the integra axles. NOT the b16a SIR shaft that came with the motor.
~kris
~kris