lime91crx

do you know or could you find out what i have to do to make a 89 integra mototr its a d16a1 with dual overhead cams but my crx is an hf what do i need to do to make it fit. i was thinking an si transmission but i wanted to see first

BTLFED

What year is your CRX? it will only bolt in an 84-87 CRX.

lime91crx

my crx is an 1991 hf it came with the 1.5

BTLFED

No it won't bolt in.

jaje

you'll have to fab custom mounts, and probably a custom shift linkage to get it to work...aside from that you will most likely have other fabrication issues

Gasoline Fumes

You might only need to fabricate one mount if you use a 1988-91 Civic/CRX transmission.

lime91crx

ok, well i have the custom mount i need. But i wasnt sure about the transmission so Gasoline Fumes you just think if i got the si transmission it would work?.....or do all of you think it just wont work.....i have gotten on other sites and ppl have said the transmission but this guy i know said i would defantly find out on here.

LSVTECKING

your better off fabricating mounts and keeping the ZC tranny but put the Si final drive into the ZC tranny, it makes for a way better set-up

lime91crx

i cant use my transmission because the starter wont reach the flywheel. thats why i was wondering if the si transmission would work

jlicrx

you can bolt the D16A1 to the L3 Si transmission - it doesn't fit perfectly, but you can do it - 4 out of the 5 transmission attaching bolts will fit - only 1 starter bolt will fit, as there is no hole in the D16A1 block for the second bolt - personally, i don't believe it is a good situation, but you can do it and it has been done before - people who have done it say it works just fine