9005 Conversion Question
03-22-2003 | 07:41 PM
Thread Starter
Joined: Oct 2002
Posts: 1,451
Likes: 0
From: Birmingham, AL
9005 Conversion Question
What method did you use to cut the guides for the harness plugs out of the 9005 Bulbs?
03-22-2003 | 07:46 PM
Joined: Nov 2002
Posts: 8,512
Likes: 0
From: so cal 951 + 760
i used my Rotozip(Dremel)... piece of cake.
03-22-2003 | 07:48 PM
Thread Starter
Joined: Oct 2002
Posts: 1,451
Likes: 0
From: Birmingham, AL
dangit i dont have a dremel, any other ways?
03-22-2003 | 08:26 PM
03-22-2003 | 08:40 PM
Thread Starter
Joined: Oct 2002
Posts: 1,451
Likes: 0
From: Birmingham, AL
a dremel is like an electronic tool with interchangable tips that rotate really fast. yeh im using a knife... one down one go to
03-22-2003 | 08:51 PM
Thread Starter
Joined: Oct 2002
Posts: 1,451
Likes: 0
From: Birmingham, AL
Well, I finally got it... thanks.
03-22-2003 | 08:57 PM
Joined: Jan 2003
Posts: 260
Likes: 0
From: Maryland, USA
and the spinning thingy on the dremel is small enuf to take out the tiny guides?
03-22-2003 | 09:19 PM
Thread Starter
Joined: Oct 2002
Posts: 1,451
Likes: 0
From: Birmingham, AL
yes, there are millions of attatchments you can buy that plug into the tip that spins
03-22-2003 | 09:51 PM
Joined: Mar 2003
Posts: 274
Likes: 0
You can always use a knife and a gas stove.
03-22-2003 | 11:14 PM
Joined: May 2002
Posts: 6,903
Likes: 0
From: Southside foo!!
I used the Carpet cutting knife, worked like a charm
: 1.........2..........3 and poofs, it gone
03-22-2003 | 08:26 PM
, took me a freakin hour to remove those 2 damn guides on both bulbs usin a pocket knife!
