Notices

OBD 1 CEL codes...here....

Thread Tools
 
Old 05-07-2003 | 05:34 AM
  #1  
crucial Si's Avatar
crucial Si
Thread Starter
Banned
 
Joined: Mar 2002
Posts: 8,220
Likes: 0
Default OBD 1 CEL codes...here....

please make this a sticky...so we dont have to search any other sites...thanks.

long flash = 10
short = 1

1 Oxygen Sensor "A" (Primary)
defective circuit or unplugged / defective sensor

2 Oxygen Sensor "B"
defective circuit or unplugged / defective sensor

3 MAP Sensor (Manifold Absolute Pressure)
defective circuit or unplugged / defective sensor

4 CKP Sensor (Crankshaft Position Sensor)
defective circuit or unplugged / defective sensor

5 MAP Sensor (Manifold Absolute Pressure)
mechanical problem / disconnected piping

6 ECT Sensor (Engine Coolant Temperature)
defective circuit or unplugged / defective sensor

7 TP Sensor (Throttle Position)
defective circuit or unplugged / defective sensor

8 TDC Sensor (Top Dead Center)
defective circuit or unplugged / defective sensor

9* CYP Sensor (Cylinder)
defective circuit or unplugged / defective sensor
* not a valid code for any throttle body injection Hondas
** not a valid code for V-6 engines

10 IAT Sensor (Intake Air Temperature)
defective circuit or unplugged / defective sensor

12 EGR Lift Sensor (Exhaust Gas Recirculation)
defective circuit or unplugged / defective sensor
* not a valid code if car is not equipped with an EGR valve (some Civic models are not)

13 BARO Sensor (Atmospheric Pressure)
defective circuit or unplugged / defective sensor

14 IAC Valve (Idle Air Control)
defective circuit or unplugged / defective sensor

15 Ignition Output Signal
missing or defective ignition output signal

16 Fuel Injector System
defective circuit or unplugged / defective fuel injector

17 VSS (Vehicle Speed Sensor)
defective circuit or unplugged / defective sensor

19 Automatic Transmission Lock Up Control Solenoid Valve
defective circuit or unplugged / defective solenoid valve

20 Electrical Load Detector
defective circuit or unplugged / defective sensor

21* VTEC Solenoid Valve
defective circuit or unplugged / defective solenoid valve
* not a valid code if car does not have a VTEC engine
** not with V-6 engine

22* VTEC Oil Pressure Switch
defective circuit or unplugged / defective oil pressure switch
* not a valid code if car does not have a VTEC engine

23 KS (Knock Sensor)
defective circuit or unplugged / defective sensor
* not a valid code if V-6 engine

30 Automatic Transmission Signal: "A" / SEAF / SEFA / TMA or TMB
defective circuit or unplugged / defective sensor
* not a valid code for 1996

31 Automatic Transmission Signal "B"
defective circuit or unplugged / defective sensor

41 Primary Oxygen Sensor - Heater
circuit malfunction

43 Fuel Supply System
defective or malfunctioning fuel supply system

45 System Too Lean or Too Rich
malfunction in the fuel monitoring systems

48 LAF Sensor (Lean Air Fuel)
defective circuit or unplugged / defective sensor

54 CKF Sensor (Crankshaft Speed Fluctuation)
defective circuit or unplugged / defective sensor

58 TDC Sensor 2 (Top Dead Center)
defective circuit or unplugged / defective sensor

61 Oxygen Sensor, Heated - Sensor 1 (Primary)
high voltage, low voltage, or slow response

63 Oxygen Sensor, Heated - Sensor 2 (Secondary)
high voltage, low voltage, or slow response

65 Oxygen Sensor Heater (Secondary)
malfunctioning or defective oxygen sensor heater

67 Catalyst system Efficiency Below Threshold
malfunctioning or defective catalyst system

70 Automatic Transmission
malfunction with the automatic transmission controls

71 Cylinder 1 Misfire or a Random Misfire
a condition is present that is creating a cylinder misfire

72 Cylinder 2 Misfire or a Random Misfire
a condition is present that is creating a cylinder misfire

73 Cylinder 3 Misfire or a Random Misfire
a condition is present that is creating a cylinder misfire

74 Cylinder 4 Misfire or a Random Misfire
a condition is present that is creating a cylinder misfire

75 Cylinder 5 Misfire or a Random Misfire
a condition is present that is creating a cylinder misfire
* valid code for V-6 engine only

76 Cylinder 6 Misfire or a Random Misfire
a condition is present that is creating a cylinder misfire
* valid code for V-6 engine only

80 Exhaust Gas Recirculation
insufficient flow detected

86 ECT Sensor (Engine Coolant Temperature)
circuit range / performance problem

90 Evaporative Emission Control System
leak detected in the fuel tank area

91 Fuel Tank Pressure Sensor
low input

92 Evaporative Emission Control System
insufficient purge flow
Old 05-07-2003 | 05:58 AM
  #2  
westcoaststyle's Avatar
westcoaststyle
Still here... sorta...
 
Joined: Sep 2000
Posts: 17,177
Likes: 2
From: CO
Default

also found on www.jdmfan.com (when it's working)
Old 05-07-2003 | 07:44 AM
  #3  
crucial Si's Avatar
crucial Si
Thread Starter
Banned
 
Joined: Mar 2002
Posts: 8,220
Likes: 0
Default

Originally posted by westcoaststyle
also found on www.jdmfan.com (when it's working)
thats why i said to stick it up...so WE DONT HAVE TO GO TO THAT SITE
Old 05-07-2003 | 07:45 AM
  #4  
westcoaststyle's Avatar
westcoaststyle
Still here... sorta...
 
Joined: Sep 2000
Posts: 17,177
Likes: 2
From: CO
Default

Originally posted by crucial Si-T
thats why i said to stick it up...so WE DONT HAVE TO GO TO THAT SITE
I know! :fawk:

There's more out there though.... don't whore my thread.. :chuckles:
Old 05-07-2003 | 09:25 AM
  #5  
SpeedRacerEX-R's Avatar
SpeedRacerEX-R
Senior Member
 
Joined: Mar 2002
Posts: 1,108
Likes: 0
Default

Why don't you just bookmark this page?
Old 05-07-2003 | 10:50 AM
  #6  
crucial Si's Avatar
crucial Si
Thread Starter
Banned
 
Joined: Mar 2002
Posts: 8,220
Likes: 0
Default

Originally posted by SpeedRacerEX-R
Why don't you just bookmark this page?
becuase i though i would share with everyone..and help out..by making it a sticky..instead of others looking for it.
Old 05-07-2003 | 02:04 PM
  #7  
tararan's Avatar
tararan
Member
 
Joined: Jun 2002
Posts: 65
Likes: 0
From: Vandeberg AFB
Default

its a freecountry so i take my vote on making a sticky out of the CEL codes..




All times are GMT -8. The time now is 06:28 AM.