is there a simple way to get the error code out of my 93 honda?

on my isuzu i could put a paper clip in it and make the dash blink a error code.

I just had a motor installed(used) and after driving around 20-30min i get a check engine light. Some have told me its most likely the o2 sensor. but they are like 69$ and without a job, I need to know what the real prollem is before i spend.

 

http://www.teirney.net/civic/ECUErrorCodes.htm

There is a TWO wire BLUE connector under your dash right beside the computer. If you dont know were the computer is its on the passenger side by the feet on the right side. good luck

 

http://www.profxtech.com/illuzion/ecucodes.htm

sorry wrong generation.
but ya you do the same paperclip trick you used on the other car. good luck

 

so i just short the 2 connectors?

 

YAY! i shorted them and got my error code, looks like 1 long and 7 short, im not quite sure what that means though, if i referenced the chart right, its my fuel injection system?

 

I FREAKIN FIGURED IT OUT!!! thanx alot! its the freekin Vehichle Speed Sensor! that explains both prollems so now i just gotta figure out what the hell that is and where

 

It's on the tranny, near the back, but still on the top. 3 wire plug on it. If you need one for a D series engine, let me know. I can hook you up!