wholy 650 dollar header

 

:chuckles: i bought the bulk of my turbo set up for 650, you NA guys crack me up

 

you turbo guys trip me out too, all of these deals that you guys find. When I wanted to go turbo on my ls motor, I could never find these deals, so I went the more expensive route of all motor. Anyhow, I went around town trying to find a 2.5 inch gasket and flange setup to fit the header for my new 2.5 inch exhaust setup, and guess what, I couldnt find anything so what I think I am going to do is get another flat flange, mill it it out about .01 and put a piece of 2.5 inch pipe on the pipe expander and make a slip fit flange. I will have a peice of flex pipe behind the flange for the sake of not cracking my header and plan on a really long resonator to take some of the raspyness out of the exhaust note. I will be using an es oval probably or a tanabe hyper medalion. I will take pictures of the progress that I make over the next few days and put all of it in this thread, I think it will be fun and leave my pockets BROKE.

 

ok, a few installed pics and a short run of how i put it on...
i made a slip fit flange with a flat 2 bolt flange and put a flat gasket between the two, no leaking!!!! I think the slip fit on the header may be leaking a VERY small amount, I am going to check for carbon tracing around the joints in a few days to see whats what. Now to the pics, installed...

 

more pics...

 

Hawt.